This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:
s 2EORIENT OR RELOCATE THE RECEIVING ANTENNA s )NCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER s #ONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH the receiver is connected. s #ONSULT THE DEALER OR AN EXPERIENCED RADIO 46 TECHNICIAN FOR HELP
Remote Controls 4O SATISFY &## 2& EXPOSURE COMPLIANCE REQUIREMENTS THIS DEVICE SHOULD BE USED in hand-held, hand operated configurations only. The device and its antenna must maintain a separation distance of 20 cm or more from the person’s body, EXCEPT FOR THE HAND AND WRISTS TO SATISFY 2& EXPOSURE COMPLIANCE 4HIS DEVICE is designed to be used in a person’s hands and its operating configurations do NOT SUPPORT NORMAL TRANSMISSIONS WHILE IT IS CARRIED IN POCKETS OR HOLSTERS NEXT TO a person’s body.
© 2008 Directed Electronics. All rights reserved.