X hits on this document

PDF document

FUZEBLOCKS FZ-1 FUSE BLOCK INSTALLATION - page 6 / 13

37 views

0 shares

0 downloads

0 comments

6 / 13

Assembling Components Onto The Lift Support Tray Panel

I pre-wired all 6 circuits for fuse panel and (hereafter) over-wrapped them all with electrical tape into a bundled wire harness.

I didn’t have a handy-sized wooden lift knob laying around. Did have a tiny little U-bolt clamp designed for clamping steel-braid cable, so I used that plus a D-ring for a tray lift pull-up handle. That worked out nice since the D-ring can fold relatively flat.

I located a rubber wire grommet with central circumferential groove wide enough to accommodate the thickness of the trunk’s front body-wall at Lowes Building Supply store. You’ll need a grommet with a fairly wide groove in it.

I used white plastic self-adhesive-backed wire retainer holders from local hardware store, which have large lever-handles for ease of opening and closing the retainers.

Power socket & fuse block mounted on tray, with fuse block cover installed.

Document info
Document views37
Page views37
Page last viewedWed Jan 18 08:29:25 UTC 2017
Pages13
Paragraphs71
Words3114

Comments