X hits on this document

Word document

30 CFR Part 46 Instructors Guide - page 13 / 24

77 views

0 shares

0 downloads

0 comments

13 / 24

30 CFR Part 46

Training Program Guide

New Miner Training ('46.5)

Newly-Employed Experienced Miner ('46.6)

The following lesson plan can be used as a model to train miner’s for the indicated part 46 training.

Health and safety aspects of the task assigned '46.5(b)(4); '46.6(b)(4)

Course Length: from                                                            to                                                     

Competent Instructor(s)                                                                                                                 _  

The purpose of this training is to identify safe work procedures for each major step of the miner’s assigned task.

Job hazards will be addressed during job training.  Potential hazards will be identified and explained for each job step.  Explain how to avoid each hazard in turn, and where appropriate, ways to avoid the hazard. Where feasible demonstrate correct procedures.  Related health and safety standards will be discussed for each potential hazard.

Training materials:MSHA-produced job safety analysis materials for appropriate jobs

30 CFR Part 56

MSHA-produced “On-the-Job Training Modules” for appropriate jobs

I will demonstrate the job for you and explain what I am doing, why I’m doing it, the expected results of my action and the potential consequences of the action.  The job steps will be explained in the order you will normally perform them.  I will identify ways you may be hurt doing each step.  I will also show you ways to avoid being hurt.  Please ask questions at any stage or ask if the step needs to be repeated. I will be asking you to demonstrate and explain each step back to me at the end of the training.

You have been assigned to                                           .

The first job step is                                           .  

You do this by                                        .

You could be hurt if                                          .

You can keep this from happening by                                         .

The MSHA standards that apply to this step are                              .

The second (etc.) job step is                                      .

You do this by                                        .

You could be hurt if                                          .

You can keep this from happening by                                         .

The MSHA standards that apply to this step are                              .

Document info
Document views77
Page views77
Page last viewedSun Dec 11 06:58:59 UTC 2016
Pages24
Paragraphs397
Words4888

Comments