X hits on this document

71 views

0 shares

0 downloads

0 comments

9 / 31

ALLARD SERVICE MANUAL

GROUP (2)

in addition to all the lubrication and maintenance operations i

Rear Axle Draining and Lubrication

The gear oil in the rear axle should be drained off and the hou 'extreme pressure' gear oil should then be put in until it reaches the level of the oil filler

Gearbox Draining and Lubrication

Drain the oil from the gearbox after removing the drain plug at

Pour the lubricant in through the filler hole located at the right hand side of the housing until it reaches the level of the hole Gearbox capacity is approximately

Front Wheel Hub Lubrication

h the front wheel hub caps taken off or e removed and the bearings and the inside of the hubs washed clean with paraffin and repacked with a good quality wheel bearing gr

Shock Absorbers (Lever Type)

Cheek the level of the fluid in the shock absorbers and add sufficient fluid until it reaches the level of

Shock Absorbers (Telescopic)

No maintenance necessary except renewal of rubber bushes in mou

Ignition

low speeds and loss of power indicates required the gaps between the contact

Battery

ections are corroded and smear well

9|P a g e

Document info
Document views71
Page views71
Page last viewedFri Dec 09 11:58:07 UTC 2016
Pages31
Paragraphs535
Words5162

Comments