X hits on this document

33 views

0 shares

0 downloads

0 comments

1 / 5

PRODUCT INFORMATION

SYNTEKO BEST

1643 matt, 1644 semi-gloss, 1645 gloss

Synteko BEST is a two-component waterborne floor finish for parquet and wooden floors. The finish can be used both on unfinished and pre- finished surfaces.

AREA OF USE:

Subjected for surfaces to heavy wear

PRODUCT PROPERTIES:

  • high resistance to wear

  • maximum resistance to scratching, scuffing and marring

  • very good resistance to grease, water, alcohol and

household chemicals

  • low-odour

  • easy to use

  • non-yellowing

COVERAGE:

  • 8-15 m²/L, depending on tools and wood species.

TOOLS:

  • Applicator with mohair felt. Approx. 5 mm pile high 300-500

mm width

  • Roller with synthetic material approx 8 mm pile high

  • Clean tools with water immediately after use.

TECHNICAL DATA:

Base material

Waterborne acrylic/polyurethane dispersion

Hardener

Solids content pH Viscosity

Polyisocyanate diluted in

dipropyleneglycoldimethyleether Approx. 31% (ISO 3251 )

Approx. 8,0 Approx. 20 sec. (ISO 2431 )

Density

Approx. 1040 kg/m³ (ISO 2811-1 ) (8,68 lb/gal US) (10,42 lb/gal UK)

Abrasion resistance

Approx. 3,1 mg/100 revs. (SIS 92 35 09)

Gloss (measured at 60°)

Approx. 20 for matte, approx. 45 for semi-gloss, approx. 90 for gloss

Drying time at 23°C (73°F)/ 50% RH

Sealer coat approx. 1 hour Second coat approx. 4 to 6 hours Further coats approx. 4 to 6 hours

Storage

Store frost-free. Must be stored between +10°C (+50°F) and +30°C (+86°F)

Self life Package size

12 months in unopened container from production date (s. package)

5L

ATTENTION!

  • Waterborne floor finishes must not be covered with solventborne finishes.

  • Wood that has been chemically treated or mechanically compressed can not be finished with waterborne finishes.

  • Oily and resinous wood species such as teak should be coated immediately after machine sanding.

  • Stained floors should not be sealed but finished directly with Synteko Star or Best.

  • Tape must not be used on waterborne finishes.

  • All finishes should be shaken before use. Do this before vacuuming so that the air mixed into the finish during shaking has a few minutes to escape before use.

  • Do not apply more than two coats per day (sealer and/or finish).

BEFORE USING THE FLOOR

  • The floor can be used with caution 24 hours after the last coat is applied.

  • Furniture can be placed after 24 hours.

  • Allow the moisture to evaporate for one week before laying rugs.

  • Final curing of surface after 4 weeks.

  • Do not clean floor with water or detergents during the first month.

  • Attach felt pads to the legs of chairs and tables in order to avoid scratching the finish.

  • The surface must not be covered with non-porous protective materials.

1

Document info
Document views33
Page views33
Page last viewedTue Dec 06 18:57:22 UTC 2016
Pages5
Paragraphs164
Words2291

Comments