X hits on this document

30 views

0 shares

0 downloads

0 comments

3 / 5

SYNTEKO WATERBASED FINISHES CARE AND MAINTENANCE

Surfaces treated with Synteko floor finishes are easy to keep clean. Vacuum cleaning and, if necessary, mopping with a Synteko SuperClean 1697 solution and a well wrung cloth is normally sufficient. Marks from rubber heels, shoe polish, lipstick, ink, etc. should be removed immediately with Synteko Remover 1692 or with mineral spirits. Avoid scrubbing with coarse brush or strong detergents.

Periodic use of Synteko Newshine 1696 in high traffic areas will help to protect the floor. Synteko Newshine 1696 can also be used to restore light scratch marks.

How do I use Super Clean 1697? Vacuum or mop the floor to remove any dirt. Prepare Synteko SuperClean as follows:

  • For normal cleaning, 1 part Synteko SuperClean to 50 parts water

  • For heavy cleaning, 2–3 parts Synteko SuperClean to 50 parts water

First, pour the water into a bucket. Never pour water directly onto a wood floor. Dip a soft cloth or a sponge mop into the mixture and wring thoroughly before cleaning the floor. Synteko SuperClean is suitable for wet mops and combi-machines.

How do I use Remover 1692? Vacuum or mop the floor to remove any dirt. Prepare Synteko Remover as follows:

  • For normal cleaning, ½ - 1 part Synteko Remover to 100 parts water

  • For heavy cleaning, 2–3 parts Synteko Remover to 100 parts water

Soak a cloth in the mixture; do not pour it directly onto the floor. Wet mop, let the mixture act for a few minutes and then dry mop. Further cleaning with 1 part vinegar to 9 parts water is recommended if sanding and recoating is to be done. The floor must be completely dry before screening and recoating.

How do I use Newshine 1696? Before applying Synteko Newshine make sure that the floor is clean. Sweep, mop or vacuum the floor. Old soap, grease, polish etc. should be removed by washing with water and Synteko Remover. Apply Synteko Newshine in a thin, even layer using a damp mop or a non-flocculent cloth. Leave the floor to dry for app. 30 minutes before walking on it.

HEALTH & SAFETY INFORMATION

Safety data sheet available for professional user on request. Detailed information and guidance is provided in our MSDS (Material Safety Data Sheet) www.synteko.com. The following only represents a selection of important information.

Note: Keep out of reach of children. Safety data sheet available for professional user on request.

Our information is based on laboratory tests and is considered a guide in connection with choice of product and working method. As your working conditions are beyond our control, we do not assume any responsibility for the results. Our responsibility covers exclusively personal injury and damage to property, which actually have been proved subsequent to faults and defects inone of the products manufactured by us.

Producer: Akzo Nobel, Estonia www.synteko.com

Date 18.08.2010

Document info
Document views30
Page views30
Page last viewedWed Oct 26 04:45:55 UTC 2016
Pages5
Paragraphs164
Words2291

Comments