X hits on this document

24 views

0 shares

0 downloads

0 comments

8 / 12

The Rear Panel continued

FUSE T10AH 250V

19

20

21

  • 26.

    POST-EQ/PRE-EQ: The signal at the tube direct out can be set to either Pre-EQ or Post-EQ with this switch. With the switch in the IN position, the signal at the tube direct out is Pre-EQ. This is a direct output not affected by any EQ or boost settings. With the switch in the OUT position, the signal is Post-EQ and is controlled and modified by the tone controls, semi-parametric EQ, and the effects loop.

  • 27.

    AUX INPUT (STEREO): This dual RCA jack allows you to connect external sources such as a CD player or mp3 player. This signal comes after the FX Return but before the Master Volume.

  • 28.

    TUNER OUT: This jack supplies the only live output when the mute switch is engaged. This allows for silent tuning through an electronic tuner or killing the house send with a monitor mixer send still active.

  • 29.

    FX SEND JACK: Use this 1/4” TS unbalanced output to send a line-level output to an external effects processor (for example). The output here is affected by all controls except the volume.

Use the FX return jack to feed the returned processed signals back into the power amplifier.

8

SVT-7 PRO Bass Guitar Amplifier

33

32

31

30

29 26 28

PATCH

FX

FOOT SWITCH

POWER AMP IN

PREAMP OUT

RETURN

SEND

TUNER OUT

SPEAKER OUTPUTS

TUBE DIRECT

CLASS 2 WIRING

OUTPUT

POST-EQ PRE-EQ

AUX INPUT (STEREO)

0dB -40dB

L

GND LIFT

R

600 W @ 8

1000W @ 4Ω MIN LOAD

22

23

24 25 27

  • 30.

    FX RETURN JACK: Use this 1/4" TS unbalanced input to return the processed line-level output of an external effects processor (for example). The processor could be fed by signals from the FX send.

  • 31.

    PREAMP OUT: This jack is a direct post master preamp output for use with an external power amp. Connect the external amp’s input to this jack using a shielded instrument cable.

  • 32.

    POWER AMP IN: This jack connects directly to the internal power amp for use with an external preamp. When using an external source, connect the OUTPUT of the source to this jack using a shielded instrument cable to feed the signal into the power amp section. The internal signal is disconnected when a plug is inserted into this jack.

  • 33.

    FOOTSWITCH: Connect a dual footswitch to this jack for remote Mute and FX On/Off control. On the stereo 1/4” plug, the tip controls Mute and the ring controls FX On/Off. The Mute function is available from either the front panel or the footswitch.

NOTE: A footswitch may be purchased at your local Ampeg Dealer or ordered directly from LOUD Technologies Inc. Be sure to ask for model #AFP2.

Document info
Document views24
Page views24
Page last viewedSun Dec 04 08:09:07 UTC 2016
Pages12
Paragraphs632
Words4352

Comments