X hits on this document

93 views

0 shares

0 downloads

0 comments

12 / 36

  • ELECTRICAL WIRING:

The REMCO LUBE PUMP KIT includes all wiring and electrical hardware needed to connect on electronic monitor on the motor home dash panel and to the LUBE

PUMP in the towed vehicle.

The kit provides

for

the

automatic

control

of

the

taillights and turn signals of the towed vehicle.

NOTE:

Some motorhomes are equipped with separate turn signals and brake lights for which a special converter (not included in the LUBE PUMP KIT) will be required.

Check the parts in the kit against the parts list on page 5 to familiarize yourself with each item and to make sure none are missing.

For proper installation it is necessary for you to have available the following tools which are not provided in the kit:

  • 12 volt DC continuity tester

  • Small wire cutter, wire stripper, wire terminal

crimper

  • Electrical tape

  • Screw Driver

  • Electric Drill

  • TOWED VEHICLE ELECTRICAL INSTALLATION:

The following electrical parts are to be installed in the towed vehicle:

1 18 ft. 5 ft. 2 ft. 4 12 1 1 1 3 ft.

6-conductor socket assembly complete with mounting bracket 3-conductor cable 2-conductor cable 14 ga. Wire (white) Solid state taillight diverters ¼” female terminals ¼” male terminal Seamed spade terminal for ground connection Self-stripping wire tap connector 14 ga. Red wire for pump

NOTE 1:

Carefully study the electrical schematic diagram on Pages 32 and 33 to become acquainted with the overall wiring plan and the circuitry.

12

Document info
Document views93
Page views96
Page last viewedSun Dec 04 19:15:55 UTC 2016
Pages36
Paragraphs940
Words8062

Comments