X hits on this document

105 views

0 shares

0 downloads

0 comments

15 / 36

Step 8.

Connect the wire that goes to the taillight bulb to the “OUT” of the diverter; connect the remaining wire to either “IN” terminal of the diverter.

Step 9.

Turn ON the left turn signal. Locate the wire labeled “LEFT TURN”. Cut the wire and confirm that the turn signal light has gone OUT.

Step 10.

Strip each wire ¼”. Crimp a ¼” female terminal onto each wire.

Step 11.

Connect the wire that goes to the turn signal bulb to the “OUT” terminal of the diverter; connect the remaining wire to either “IN” terminal of the diverter. Locate the wire labeled “RIGHT TURN” and follow the same procedure.

  • INSTALLATION OF CONDUCTOR CABLE FOR 3-WIRE SYSTEMS

NOTE

:

Refer to DIAGRAM 3, page 17 for the steps listed below.

Step 1.

Route the conductor cable from the socket to the diverters.

Step 2.

Separate the towed vehicle’s conductor cable sufficiently to attach to the diverters.

Step 3.

Strip each wire ¼”. Crimp a ¼” female terminal onto the yellow, green, and brown conductor wire.

Step 4.

Locate the “TAILLIGHT” diverter. Connect the brown conductor wire to the remaining “IN” terminal of the diverter.

Step 5.

Locate the “LEFT TURN” diverter. Connect the yellow conductor wire to the remaining “IN” terminal of the diverter.

Step 6.

Locate the “RIGHT TURN” diverter. Connect the green conductor wire to the remaining “IN” terminal of the diverter.

INSTALLATION OF DIVERTERS FOR 4-WIRE SYSTEMS

NOTE #1

This system uses all 4 diverters supplied in this kit.

gain

to

removed

be

must

assembly

NOTE

#2

With some vehicles, the taillight access to the taillight wires.

15

Document info
Document views105
Page views108
Page last viewedWed Dec 07 16:37:57 UTC 2016
Pages36
Paragraphs940
Words8062

Comments