X hits on this document

100 views

0 shares

0 downloads

0 comments

16 / 36

Step 2.

Turn ON the taillights.

Step 3.

Ground the continuity tester to a suitable ground.

Step 4.

Probe each wire to locate a “HOT” wire. Turn OFF and ON the taillight switch to verify the correct wire. Label the wire “LEFT TAILLIGHT”. Follow the same procedure for the passenger side taillight assembly, but label the wire “RIGHT TAILLIGHT”. Turn OFF the taillights.

Step 5.

Have an assistant depress the brake pedal. Start at the driver side taillight assembly. Probe each wire for a “HOT” wire. Have the assistant depress the brake pedal ON and OFF to verify the correct wire. Label the wire

NOTE #3

The amber turn signals are not used, instead, the brake lights become the turn signals and brake lights for towing only.

NOTE #4

Refer to DIAGRAM 4, page 17, for steps listed below.

“LEFT TURN/BRAKE”. follow the same procedure,

For the passenger side but label the wire “RIGHT

taillight assembly, TURN/BRAKE”.

Step 1.

the

for

wires

the

Access

assembly.

taillight

Start at the driver taillight assembly.

side

Step 6.

Refer to DIAGRAM

assembly.

Turn

ON

4, page 17; return to the driver side the taillights; locate the wire labeled

taillight “LEFT

TAILLIGHT”. OFF taillights.

Cut the wire. Confirm that Strip each wire ¼” crimp

the the

taillight goes OUT. ¼” female terminals

Turn onto

each

wire.

Connect

the

wire

that

goes

to

the

taillight

bulb

to

the

“OUT”

terminal terminal the wire above.

of the diverter.

Connect the remaining wire to either “IN”

of the diverter. labeled “RIGHT

For the passenger side taillight assembly, locate TAILLIGHT” and follow the same procedure as

Step 7.

Return to the driver side taillight assembly. Have the assistant depress the brake pedal. Locate the wire labeled “LEFT TURN/BRAKE”. Cut the wire. Confirm that the brake light goes OUT. Strip each wire ¼”. Crimp the ¼” female terminals onto each wire. Connect the wire that goes to the brake light bulb to the “OUT” terminal of the diverter. Connect the remaining wire to either “IN” terminal of the diverter. For the passenger side taillight assembly, locate the wire labeled “RIGHT TURN/BRAKE” and follow the same procedure as above.

Step 8.

Install conductor cable.

16

Document info
Document views100
Page views103
Page last viewedMon Dec 05 23:14:46 UTC 2016
Pages36
Paragraphs940
Words8062

Comments