X hits on this document

92 views

0 shares

0 downloads

0 comments

18 / 36

INSTALLATION OF CONDUCTOR CABLE FOR 4-WIRE SYSTEMS DRIVER SIDE ROUTING OF CONDUCTOR CABLE

NOTE #1

Refer to DIAGRAM 5, page 20 for the following steps.

NOTE #2

For driver and passenger side conductor cable installation, two separate wires will be routed between the driver side taillight assembly, either inside the trunk area or underneath the vehicle.

Step 1.

Route the conductor cable from the socket underneath the vehicle along the driver side to the driver side taillight assembly.

Step 2.

Separate the conductor cable wires sufficiently to attach the diverters;

strip

each

wire

¼”.

Crimp

a

¼”

female

terminal

onto

the

yellow

remaining

“IN”

the

conductor wire. Connect the yellow conductor wire terminal of the “LEFT TURN/BRAKE” diverter.

to

Step 3.

Crimp a Connect diverter.

yellow female terminal onto the red/brown two-conductor wire. it to the remaining “IN” terminal of the “LEFT TAILLIGHT” Attach a separate wire onto the brown conductor wire and

extend it to the “RIGHT TAILLIGHT” diverter. ¼”. Crimp a ¼” female terminal onto the wire. remaining “IN” terminal of the diverter.

Strip the separate wire Connect the wire to the

Step 4.

Attach a separate wire to the green conductor wire. Extend the separate wire to the passenger side taillight assembly. Locate the diverter labeled

“RIGHT TURN/BRAKE”.

Strip the wire ¼”.

Crimp

terminal onto the wire. of the diverter.

Connect the wire to the remaining

a ¼” female “IN” terminal

Step 5.

Test the lube pump, diverter, and conductor cable installation before starting the installation of the lube pump parts on the motor home.

INSTALLATION OF CONDUCTOR CABLE FOR 4-WIRE SYSTEMS PASSENGER SIDE ROUTING OF CONDUCTOR CABLE

NOTE

Refer to DIAGRAM 6, page 20 for the following steps.

Step 1.

Route the conductor cable from the socket underneath the vehicle along the passenger side to the passenger side taillight assembly.

Step 2.

Separate the conductor cable wires sufficiently to attach the diverters. Strip each wire ¼”. Crimp a ¼” female terminal onto the green conductor

18

Document info
Document views92
Page views95
Page last viewedSat Dec 03 07:03:43 UTC 2016
Pages36
Paragraphs940
Words8062

Comments