X hits on this document

113 views

0 shares

0 downloads

0 comments

21 / 36

MOTORHOME ELECTRICAL INSTALLATION:

The following parts are to be installed on the motor home:

1 1

40 ft. 3 ft. 2 ft. 2 3 1 5 1 4

Electronic Monitor Motorhome harness 6-conductor socket assembly complete with mounting bracket 2-conductor cable 3-conductor cable for taillights and turn signals 14 ga. White wire for ground Seamed spade terminals Seamed butt connectors Maple slip on tab terminal Self-stripping wire tap connectors 3/8” ring terminal #6 self tapping screws

NOTE:

Quick-disconnect plug has been manufactured into the back of the Electronic Monitor. This allows for easy replacement of the unit should it become necessary. Simply unplug the harness from the back of the monitor.

Step 1.

Select a suitable location for the Electronic Monitor under the dashboard of the motorhome. The location should be conveniently located for the driver. Screws are provided for it’s mounting (4 - #6 self tapping screws).

Step 2.

Turn the ignition key of the motorhome to the ON position. Use a 12 volt DC continuity lamp tester to identify an appropriate accessory ignition

INSTALLATION OF ELECTRONIC MONITOR

Step 3.

Cut the fused orange wire from the monitor to a appropriate length. Strip the end of the orange ¼” and crimp a male tab terminal onto the wire. Connect the orange wire to the ignition terminal located in step 2.

Step 4.

Cut the white wire to an appropriate length, strip the end of the wire ¼”, crimp a seamed spade terminal onto the wire; attach the wire to a suitable ground as previously described.

terminal connection at the motorhome chassis ignition key OFF and ON to make certain that only when the ignition key is turned ON.

fuse box.

Switch the

the

terminal

is

HOT

21

Document info
Document views113
Page views116
Page last viewedFri Dec 09 21:14:51 UTC 2016
Pages36
Paragraphs940
Words8062

Comments