X hits on this document

95 views

0 shares

0 downloads

0 comments

25 / 36

Step 1.

To test the wiring just completed, first turn ON the ignition switch in the motor home with towed vehicle connected. The monitor will go through a series of blinking lights and tones until the lube pump comes up to pressure (red-green-red-green) when the pump reaches pressure(10 to 15 seconds) the indicator light will stay on green indicating your system is ready to tow.

Step 2.

After you have completed step 1 above and found that the monitor blinks a pattern of (red-yellow) or (solid red) or (solid yellow) refer to the legend next to the lights. These will tell you what to look for to correct your problem.

Step 3.

To test the wiring completed in the towed vehicle to the rear socket of the motor home using the coiled cable provided. If the plug feels loose in the socket, the pins in the socket can be spread with a slotted screwdriver so contact is tight.

Step 4.

Turn ON the taillights and left and right turn signals to confirm that each respective light glows on the towed vehicle.

Step 5.

This completes the installation and testing of the LP-1 system.

TESTING THE INSTALLATION

NOTE:

WHEN INSTALLATION INSTALLER NEEDS TO

INSTRUCTION

BOOKLET

TO

THE

CUSTOMER.

ALSO,

THE

HAS BEEN

COMPLETED, THE

RETURN

THE INSTALLATION

WARRANTY CARD INCLUDED IN THE BOOKLET NEEDS BE COMPLETED AND RETURNED TO REMCO MFG.

TO

25

Document info
Document views95
Page views98
Page last viewedMon Dec 05 08:50:19 UTC 2016
Pages36
Paragraphs940
Words8062

Comments