X hits on this document

98 views

0 shares

0 downloads

0 comments

4 / 36

THE REMCO LUBE PUMP

REMCO’s Lube-Pump provides a proven, safe and reliable method of towing a front wheel drive automatic transmission vehicle behind your motor home with all four wheels on the ground. REMCO provides the pump system, tail light system and all electrical connections. REMCO can provide the tow bar and brackets for most vehicles.

A durable 1/8 horsepower self-priming pump provides effective lubrication of the towed vehicle’s transmission while being towed. The pump is switched on and off from the control panel of an electronic monitor conveniently mounted under the dashboard of your motor home.

The motor home is connected to the towed vehicle with a single cable, which operates the pump, monitor, and the towed vehicle’s taillights. When the cable is connected, the taillights, brake lights, and turn signals of the towed vehicle are automatically controlled from the motor home. When the cable is disconnected, the taillights, turn signals, and brake lights of the towed vehicle operate normally.

In addition, a fail-safe electronic alarm system is built into the monitor, giving you a visual and audible signal if for any reason your LUBE-PUMP is not delivering adequate lubrication. One more unique feature of the alarm system is when you plug your towed vehicle into your motor home, with the motor home ignition ON, the red light and alarm will operate until the monitor switch is turned ON and the pump begins operating so you don’t drive down the road with the pump shut off and ruin your transmission.

The REMCO LUBE-PUMP has been designed to give you maximum convenience and safety when the system is properly installed. Please follow the installation instructions very carefully. If you have any questions or problems call REMCO at 1-800-228-2481.

NOTE:

AN INSTALLATION VIDEO SHIPPING AND HANDLING

IS

AVAILABLE

FOR

$10.00

+

  • *

    * WARNING * *

SAFETY FIRST Use caution when working on a vehicle. Do not get hands into fan belts or other moving parts. Do not get under any vehicle that is supported by a jack only. Be sure vehicle is properly blocked and supported by jack stands before getting under it.

CAUTION An improperly installed LUBE-PUMP system can cause failure of the towed vehicle’s transmission and other system components. All motor home electrical power used for the monitor, pump, or towed vehicle’s taillights must be 12 volts DC. Bus type chassis may have 24 volt DC electrical system and will need to be converted to 12 volts DC.

4

Document info
Document views98
Page views101
Page last viewedMon Dec 05 18:48:41 UTC 2016
Pages36
Paragraphs940
Words8062

Comments