X hits on this document

49 views

0 shares

0 downloads

0 comments

10 / 17

  • 2.

    GENERAL INSTALLATION REQUIREMENTS

  • 1.

    Install in accordance with reference standards and manufacturer's instructions,

and as required to comply with seismic requirements.

  • 2.

    Tolerances:

  • 1.

    Do not exceed 1/8 inch in 8'-0" variation from plumb or level in

exposed lines of surface, except at joints between gypsum board units.

2. Do not exceed 1/16 inch variation between planes of abutting edges or ends.

  • 3.

    Shim as required to comply with specified tolerances.

  • 3.

    Install framing to comply with ASTM C754 and with ASTM C840 requirements

that apply to framing installation.

    • 4.

      Install supplementary framing, blocking and bracing at terminations in gypsum board assemblies to support fixtures, equipment, heavy trim, grab bars, toilet accessories, furnishings or similar construction.

  • 3.

    METAL SUPPORT INSTALLATION

  • 1.

    Metal Runners:

  • 1.

    Align and secure runner tracks accurately to partition layout at both floor

and ceiling.

    • 2.

      Provide fasteners appropriate to substrate construction as recommended by manufacturer.

  • 2.

    Metal Studs:

1. Position metal studs vertically in the runners, spaced as indicated.

************************************************************************************************************

INCLUDE STUD GAGE AND FRAMING MATRIX HERE AT FUTURE DATE

************************************************************************************************************

  • 2.

    Place studs so that flanges face in same direction.

  • 3.

    Cut studs ½ inch short of full height to provide perimeter relief.

  • 4.

    Align and plumb partition framing accurately.

  • 5.

    Where partitions abut ceiling or deck construction or vertical structural

elements, provide slip or cushion type joint between partition and structure as recommended by stud manufacturer to prevent transfer of structural loads or movements to partitions, and to provide lateral support.

Document info
Document views49
Page views49
Page last viewedTue Jan 17 07:49:19 UTC 2017
Pages17
Paragraphs628
Words4464

Comments