X hits on this document

44 views

0 shares

0 downloads

0 comments

17 / 17

3. Thoroughly mix plaster with proper amount of water until uniform in color and consistency.

    • 4.

      Retempering not permitted; discard plaster which has begun to stiffen.

  • 3.

    Base Coat:

    • 1.

      Trowel apply base coat plaster over gypsum base to thickness of 1/16

inch to 3/32 inch.

    • 2.

      Where plaster is flush with metal frames, groove at junction to reduce possibility of chipping. Cut plaster free from these metal sections before plaster sets.

  • 4.

    Finish Coat:

1. Trowel apply finish coat plaster to a maximum 1/16 inch thickness over base coat plaster.

2. Scratch finish coat in thoroughly over dry base coat and immediately double back to true even surface.

3. Finish surface to flat, smooth, hard trowel finish.

************************************OR********************************************************************

  • 4.

    Finish surface to uniform float texture

  • 5.

    Perform cutting, patching, repairing and pointing-up operations neatly

and thoroughly. Repair cracks and indented surfaces by moistening plaster and filling with new material, troweled flush with adjoining surfaces.

  • 9.

    ADJUSTING

    • 1.

      Correct damage and defects, which may telegraph through finish Work.

    • 2.

      Leave Work smooth and uniform.

Document info
Document views44
Page views44
Page last viewedThu Dec 08 06:51:58 UTC 2016
Pages17
Paragraphs628
Words4464

Comments