X hits on this document

37 views

0 shares

0 downloads

0 comments

7 / 17

4. Casing beads (edge beads): Equivalent to 200A [ 200B] [401] [402] [P- 1] [701-B] [801-A] [801-B] by USG.

    • 5.

      Control joints:

      • 1.

        Roll-formed zinc with perforated flanges.

      • 2.

        Size: 1-3/4 inch wide, with 1/4 inch wide center channel.

      • 3.

        Provide with removable tape strip over channel.

      • 4.

        Acceptable product: Equivalent to No. 093 by USG.

  • 2.

    Metal Trim for Veneer Plaster:

    • 1.

      Conform to profile and dimensions indicated.

    • 2.

      Material: Galvanized steel, 26 gage minimum.

    • 3.

      Corner beads: Equivalent to No. 900 by USG.

    • 4.

      Casing beads: Equivalent to No. 701-A (channel-type edge) or No.

701-B (angle edge) by USG.

5. Control joints: Roll-formed zinc with perforated flanges. Acceptable product:Equivalent to No. 093 by USG.

************************************************************************************************************

Control joint locations and spacing should be designated by Architect.

************************************************************************************************************ 3. Adhesives and Joint Treatment Materials: Adhesives and Joint Treatment Materials:

  • 1.

    Conform to requirements of ASTM C475.

  • 2.

    Joint compounds:

  • 1.

    Drying-type (ready-mixed): Equivalent to SHEETROCK

Taping Joint Compound and Topping Joint Compound, or SHEETROCK All Purpose Joint Compound [or Lightweight All Purpose Joint Compound Ready-Mixed ] by USG.

************************************************************************************************************

SHEETROCK Taping Joint Compound Ready-Mixed is a high-performance product for embedding tape and is also used for laminating.

SHEETROCK Topping Joint Compound Ready-Mixed is a low-shrinkage, easily applied and sanded product recommended for second and third coats over ready-mixed taping and all purpose compounds. Also used for simple hand-applied texturing or skim coating in some markets; check suitability of formula in your area with local sales office. Not suitable for embedding tape or as first coat over metal corners, trim and fasteners.

Document info
Document views37
Page views37
Page last viewedMon Dec 05 02:21:51 UTC 2016
Pages17
Paragraphs628
Words4464

Comments