X hits on this document

137 views

0 shares

0 downloads

0 comments

18 / 59

ECU Programming and Configuration Management Software

Operating system: Windows 2000, Windows ME, Windows XP and Vista. PC Requirements: 1.2 GHz processor VGA colour display with 800x600 resolution (preferably 1024x768) 128MB of memory 40 MB of free Disk space

Installing the software

Installation is similar to any other windows software.

  • 1.

    Insert the CD-ROM into your PC’s CD-ROM drive.

  • 2.

    The CD should auto-run the installation software. If the installation software

appears then go to step 6.

  • 3.

    Double click on the “My Computer” icon on the desktop.

  • 4.

    Double click on the CD-ROM icon to open the CD-ROM.

  • 5.

    Double click on the “EMSInstaller.EXE” icon to start the installation software.

  • 6.

    Select install the STINGER 4 software.

  • 7.

    Follow the installation steps leaving the default values.

When the installation is complete you should find the STINGER 4 Management Software icon on you desktop.

Going Online with the Software

First ensure that you have your programming cable attached to the ECU and the other end connected to your laptop.

Double-click on the STINGER 4 Management Software icon on your desktop to run the application. After the application is running, turn on the ignition to power up the ECU. If all is well you should see the message “Read from ECU”. Press the Yes button to read or NO if you do not want to read from the ECU. If you did not receive this message then you may need to tell the software which COM port number to use. This is done from the “Application Settings” -> “Operational Parameters” menu options. Select the correct COM port number, press the “Save” button and then re- start the EMS STINGER 4 Software.

Stinger 4 instruction manual version 2.0

Page

18

Document info
Document views137
Page views137
Page last viewedMon Dec 05 11:30:57 UTC 2016
Pages59
Paragraphs922
Words18078

Comments