X hits on this document

159 views

0 shares

0 downloads

0 comments

19 / 59

Loading a base map

All STINGER 4 ECUs come pre-loaded with a base map. If you requested a map for a particular engine then this would have been pre-loaded (if available). The software also has a selection of base maps for many different engines that you can choose from. Go-to the “File” then “Open Tune File” Option and then go-to the “Base Maps” folder, select a map that is suitable for your engine and press the “Open” Button. To write this map into the ECU go-to “ECU” then “Write to ECU” menu option. When the progress bars at the bottom of the screen have stopped the map will have been written to the ECU.

Warning: The base maps are not intended for driving. These should only be used to ensure that the ECU is installed correctly and the engine starts. The engine must be properly tuned and tested at a mechanical workshop before attempting to drive the vehicle.

Stinger 4 instruction manual version 2.0

Page

19

Document info
Document views159
Page views159
Page last viewedFri Dec 09 16:26:24 UTC 2016
Pages59
Paragraphs922
Words18078

Comments