X hits on this document

160 views

0 shares

0 downloads

0 comments

2 / 59

This Installation and Wiring Guide will guide you through the installation of your STINGER 4 ECU to your vehicle.

Warning:

Always disconnect the battery cables when doing electrical work on your vehicle. The STINGER 4 ECU must be completely disconnected from the electrical system before doing any form of electrical welding on the vehicle.

Note:

Installing an engine management system is a complex exercise and should be done only after careful planning. Damage may be caused to engine components if care is not taken during the installation and set-up of any engine management system. If you are unsure about how to wire any components of your engine, please consult an experienced installer for advice.

Stinger 4 instruction manual version 2.0

Page

2

Document info
Document views160
Page views160
Page last viewedFri Dec 09 16:53:37 UTC 2016
Pages59
Paragraphs922
Words18078

Comments