X hits on this document

148 views

0 shares

0 downloads

0 comments

24 / 59

The value in this setting represents a percentage increase of fuel when the accelerator is pushed. This is normally set between 5 and 30%. The duration of the increase is defined in the "Enrichment Duration" setting.

NOTE: You will need to place an amount in the "Enrichment Duration" setting so you can correctly fine tune the accelerator enrichment.

When tuning the fuel maps at steady state, temporarily set the acceleration enrichment to 0 and don't forget to reset it back afterwards.

Enrichment Duration

Enrichment Duration sets the duration for which the fuel is added. Through acceleration testing, adjust this parameter until you have reached a satisfactory engine response. You will need to move back and forward between Acceleration Enrichment and Enrichment Duration to get the best response.

Enrichment Duration is the number of power strokes fired with extra fuel being added. Normally set to 30. but can be reduced or increased as needed. For example, setting a value of 30 cause the enrichment to last for 30 power strokes which is equivalent to 10 crank revolutions.

When tuning the fuel maps at steady state, temporarily set this to 0 and don't forget to reset it back afterwards.

Stinger 4 instruction manual version 2.0

Page

24

Document info
Document views148
Page views148
Page last viewedWed Dec 07 00:45:54 UTC 2016
Pages59
Paragraphs922
Words18078

Comments