X hits on this document

126 views

0 shares

0 downloads

0 comments

3 / 59

Table of Contents

E C U I n s t a l l a t i o n a n d w i r i n g _ _ _ _ _ Flying Lead Loom Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _____________________________________________

7 7

Mounting the ECU and relays: Connecting Sensors 7 8 _____________________________________________ ______________________________________________________ Manifold Absolute Pressure Sensor _________________________________________ 8 Engine Temperature Sensor _______________________________________________ 8 Inlet Air Temperature Sensor (optional) _____________________________________ 8 Throttle Position Sensor (Optional) _________________________________________ 9 Trigger (Reference) and Sync (Home) Sensors _______________________________ 10

ECU Wiring Diagram ___________________________________________________ Exhaust Gas Oxygen Sensors (O2 )(Optional)________________________________

11

12

Power Connections

13

Ignition Modules

_____________________________________________________ ________________________________________________________

14

Wiring Injectors

________________________________________________________

14

Auxiliary Outputs ____ Fuel Pump ___________ Auxiliary digital Inputs

__________________________________________________ __________________________________________________ __________________________________________________

15 16 17

ECU Programming and Configuration ________________________________________

18

Management Software ___________________________________________________ Installing the software __________________________________________________ Going Online with the Software___________________________________________ Loading a base map ____________________________________________________

18 18 18 19

Setting engine parameters ________________________________________________ Load Source __________________________________________________________ Engine Set-up Parameters________________________________________________ Ignition fire edge ______________________________________________________ Ignition Delay Compensation_____________________________________________ Ignition Dwell_________________________________________________________ Injector Ohms _________________________________________________________ Soft Rev Limit ________________________________________________________ Hard RPM Limit_______________________________________________________ Boost Cut ____________________________________________________________ Deceleration Fuel Cut___________________________________________________ Use Throttle Sensor ____________________________________________________

20 20 21 21 21 21 21 21 22 22 22 22

Acceleration Enrichment _________________________________________________ Sensitivity ____________________________________________________________ Intake Induction _______________________________________________________ Super Charger Boost____________________________________________________ Accelerator Enrichment _________________________________________________ Enrichment Duration ___________________________________________________

23 23 23 23 23 24

Throttle Position Sensor Calibration (only if a TPS is fitted) ___________________ Calibrate Closed Throttle ________________________________________________ Calibrate Open Throttle _________________________________________________

25 25 25

Closed Loop Lambda ____________________________________________________ Narrow Band _________________________________________________________ Wide Band ___________________________________________________________ Programming the close loop lambda function ________________________________

26 26 26 26

Stinger 4 instruction manual version 2.0

Page

3

Document info
Document views126
Page views126
Page last viewedSat Dec 03 20:10:56 UTC 2016
Pages59
Paragraphs922
Words18078

Comments