X hits on this document

142 views

0 shares

0 downloads

0 comments

50 / 59

Example 2 You can even turn an output on within a specified zone. This might be useful for VTEC cam control where you may want an output to turn ON when the RPM is greater than 2000 and stay ON until the engine reaches over 4000 RPM then turn OFF again. Set the output parameters as follows.

Mode

1 (RPM activated relay)

Rev Act

OFF (Not Ticked)

ON above RPM

2000 RPM

ON Below RPM

4000 RPM

OFF Above RPM

4000 RPM

OFF Below RPM

2000 RPM

Example 3 Outputs can also be controlled by using 2 criteria. If either of the comparison criteria produces an OFF result then the output will remain OFF.

ON Above RPM

2850

On Above KPA

- 10 KPA

ON Above RPM

OFF

ON Above KPA

Off

OFF Below RPM

OFF

OFF Below KPA

Off

OFF Below RPM

2800

OFF Below KPA

- 15 KPA

For controlling NOS you can set the system to turn on at a certain engine rpm and manifold KPA. (Pressure). If you want to activate the NOS when the engine rpm is greater than 2850 and manifold pressure is greater than -10 KPA Set the output as

follows.

For the output to turn on, RPM must be greater than 2850 AND manifold pressure must be greater than -10 KPA.

Mode Rev Act

5 (RPM & Load activated relay OFF (Not Ticked)

Stinger 4 instruction manual version 2.0

Page

50

Document info
Document views142
Page views142
Page last viewedTue Dec 06 10:36:11 UTC 2016
Pages59
Paragraphs922
Words18078

Comments