X hits on this document

565 views

0 shares

0 downloads

0 comments

162 / 220

DATEATTACHMENT 248300.10 CHG XX

If foreign manufactured, the standard of the country where manufactured, if approved by the Administrator

(b)  Special tools and equipment include those recommended by the manufacturer of the product or an FAA acceptable equivalent.

NOTE:  Although the noncertificated facility does not by regulation have to meet the requirements for calibrated tools and equipment, when aviation products are undergoing maintenance all tools and equipment used to meet airworthiness requirements must be calibrated.  The repair station must assure the noncertificated facility has a quality system equal to that of the repair station

(5)  Observe and Inspect Maintenance Functions.

(a) Verify that work for parts 121 and 125 operators is being performed in accordance with the specific operator’s manual.

(b)  Verify that maintenance being performed is in accordance with approved procedures

(6)  Conduct Debriefings.  Brief the certificate holder on the inspection results. Discuss any deficiencies and possible corrective actions.

7.  TASK OUTCOMES.

A.  Complete PTRS.

B.  Complete the Task. Completion of this task can result in the following:

Successful inspection

A letter to the certificate holder describing all deficiencies

C.  Document Task.  File all supporting paperwork in the certificate holder’s office file.

9.  FUTURE ACTIVITIES.  Schedule and conduct a follow-up inspection, as applicable.

Vol. 2

Document info
Document views565
Page views565
Page last viewedThu Dec 08 10:04:46 UTC 2016
Pages220
Paragraphs5397
Words68086

Comments