X hits on this document

Word document

NATIONAL PARTITIONS PRODUCT SPECIFICATIONS AUGUST 2009 - page 9 / 16

40 views

0 shares

0 downloads

0 comments

9 / 16

NATIONAL PARTITIONS PRODUCT SPECIFICATIONS                   AUGUST 2009

National Partitions, Inc. 10300 Goldenfern Lane, Knoxville, TN 37931

PHONE:  865-670-2100:  FAX:  865-670-2200; WEBSITE:  www.n-p.com

© Copyright 2009, Authorized use is strictly limited to parties writing specifications for National Partitions projects.

C.Post assembly:  Two-piece structural post and panel connector fabricated from 20 gage galvanized high strength steel.  Pieces are connected with bolts spaced at 20 inches and clamp on vertical edges of wall panels.

1.Post assembly design shall provide cavity for concealed electrical conduit, wire, and data cabling.

2.Where required and indicated on approved shop drawings, provide structural inserts in posts.

3.Non-progressive design:  Post assembly shall allow wall panels to be removed and replaced without disturbing adjacent panels.

4.Trim:  Fabricate from 20ga. and  26 gage galvanized steel.

a.Feature strips:  26 ga. channels snap into each side of posts to conceal fasteners and provide flush surface.

b.Corner trim:  For room corners, provide angle to conceal ends of two perpendicular wall panels and angle trim for inside corner.

D.Base channel:  Continuous, U-shaped base fabricated from 20 gage galvanized steel to anchor to floor and secure wall panels.

*****  Member at top of wall panels will vary in design based on type of roof structure, attachment method, bracing, and other specific project requirements.  *****

E.Top support member:  Provide top support member to retain wall panels and posts and provide means for attaching wall to roof structure as detailed on approved shop drawings.

F.Finish:  

*****  The steel skins of Hi Wall panels are provided with two optional finishes:

Embossed steel textured surface with baked enamel in gray or tan colors.

Smooth steel surface with white baked enamel which is USDA approved.

Edit the following paragraph to indicated selected finish.  *****

1.Wall panel finish:  [Embossed steel texture with baked acrylic [gray] [tan] enamel.]  [Smooth steel surface with baked acrylic white enamel with USDA approval.]

______________________________________________________________________________

PREFABRICATED ROOMS [Using Hi Wall System]13031-F - 9

Document info
Document views40
Page views40
Page last viewedSun Dec 04 16:22:05 UTC 2016
Pages16
Paragraphs353
Words5065

Comments