X hits on this document

14 views

0 shares

0 downloads

0 comments

1 / 4

Installation Instructions

Microwave Oven Built-In Trim Kits

JX827

Questions? Call 1-800-561-3344 or Visit our Website at: www.GEAppliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.

  • IMPORTANT – Save these instructions

for local inspector’s use.

 IMPORTANT – Observe all governing codes and ordinances.

 Note to Installer – Be sure to leave these instructions with the Consumer.

 Note to Consumer – Keep these instructions for future reference.

 Skill level Installation of this appliance requires basic mechanical and electrical skills.

 Completion time 1 to 3 hours

 Proper installation is the responsibility of the installer.

 Product failure due to improper installation is not covered under the Warranty.

 This kit is for use on models: JEM25WMC, PEM31BMC, PEM31WMC and PEM31SMC.

 This kit is cUL listed for installation alone or over any GE/GE Profile single electric wall oven.

 For easier installation and personal safety, we recommend that two people install this microwave oven.

 Unplug the microwave oven before attempting installation of this kit.

Base Pan

QUANTITY 1

Back Cover

1

Side Bracket

1

Upper Bracket

1

Bottom Bracket

1

Trim Kit

1

PARTS INCLUDED

PARTS

5 mm x 10 mm

2 required

Screw A

2 extra

Base Support Brackets

2

WARNING! This oven must be plugged into a properly grounded 3-hole, 120 volt receptacle as required by the National Electrical Code.

4 mm x 10 mm

1 required

Screw B

2 extra

4 mm x 12 mm Screw C

4 required 2 extra

4 mm x 10 mm Screw D

10 required 2 extra

4 mm x 16 mm Screw E

4 required 2 extra

FOR YOUR SAFETY:

WARNING! Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

1

Note: This kit has extra screws to prevent the technician from spending extra time locating a replacement in case they lose one during installation.

Document info
Document views14
Page views14
Page last viewedFri Dec 09 05:06:24 UTC 2016
Pages4
Paragraphs168
Words1641

Comments