X hits on this document

12 views

0 shares

0 downloads

0 comments

2 / 4

Installation Instructions

Dimension

Trim Kit

Cutout

Height

16¾”

15 ± 1/16

Width

26¼”

24 7/8 ± 1/16

TOOLS YOU WILL NEED

2 Phillips Screwdrivers (#1 & #2)

Pencil

Knife

Level

CUTOUT DIMENSIONS

Allow 1¼” for the overlap of the Microwave Oven Trim Kit over all the edges of the cutout.

Min. depth with receptacle outside cutout – 16” Min. depth with receptacle inside cutout – 18”

120V/60Hertz Grounded Power Outlet

Drill with 3/32” Bit

Centerpunch or Nail

Tape Measure

1 LOCATE AND INSTALL THE REAR HOLDDOWN SUPPORTS

V Notch

Screw D

120 volt ¨C 60 Hertz grounded power receptacle. 1¼” Overlap

Depth

1¼” Overlap

B

Slide the two base support brackets from the rear into the slots in the base pan. The tongues of the base support brackets should protrude into the base, be centered in the slot, and be into the slot as far as they will go. Mark and drill four 3/32” diameter holes. Mount the base support brackets using four screws (D). Both base support bracket tongues should now be centered in the slotted holes in the base and be into the base as far as they can go.

A

Set base pan into the front cabinet microwave oven cutout and center it right and left. Push back until the front flange is against the cabinet front wall. Using the V-notch in the base pan front flange, mark the location of the V-notch on the cabinet to use as a reference.

Width

Height

1” clearance beyond trim frame (on all sides)

1¼” Overlap

3” Min.

WARNING! This trim kit uses air flow from the top, bottom and sides of the trim frame. Blocking the air flow can cause the microwave to function improperly and may cause damage to the microwave. Allow a 1” clearance beyond the edge of the trim frame to provide proper air flow.

Base Support Brackets

1 Ft = 0.3 m 1” = 2.5 cm

FOR INSTALLATION ABOVE A BUILT-IN OVEN:

Microwave oven should be installed on a 3/8” plywood base and supported by 2 x 4 or 1 x 2 equivalent runners on all sides. Base must be capable of supporting a minimum of 100 lbs.

2

Document info
Document views12
Page views12
Page last viewedMon Dec 05 19:29:19 UTC 2016
Pages4
Paragraphs168
Words1641

Comments