X hits on this document

11 views

0 shares

0 downloads

0 comments

3 / 4

Installation Instructions

2 INSTALL THE BASE PAN

4 INSTALL THE BACK COVER

Disconnect the microwave oven from the receptacle. Remove everything out of the microwave oven, including packing, temperature probe, Owner’s Manuals, turntable and turntable support. Remove the two top plug buttons from the top of the microwave oven cabinet. Use a knife to pry up the plug buttons, using care not to scratch the microwave oven. A clear protective film has been applied to some microwave ovens and trim kits. If applied, remove the film. Place the microwave oven on the base pan.

Use the tabs on the bottom of the back cover to place the back cover on the base pan at the bottom of the open slot (just below the bottom edge of the oven). Lift the back cover up and into place against the back surface of the oven, and align the screw holes. Drive two screws (D) through the back cover and into the back surface of the oven.

CAUTION! Start all screws before tightening any

one screw.

A

S

ecure

t h e b a s e p a n t o t h

e o v e n b y i n s e r t i n g

B

2 screws (D).

Centered left to right.

Back Surface of Oven

Remove 2 front plug buttons

Screw D

5 INSTALL THE TOP BRACKET

Screw D

Install by placing the top bracket on the front edge of the top of the oven, and aligning the two screw holes. Drive two screws (A) through the top bracket, and into the top of the oven.

3 INSTALL THE SIDE BRACKET

Install by inserting the tab of the side bracket into the slot on the left side of the base pan, just below the bottom edge of the oven. Lift the side bracket up and into place against the side of the oven, and align the screw hole in the side bracket with the dimple in the oven. Carefully drive one screw (B) through the side bracket into the side of the oven, using a screwdriver or power drill. Be sure the side bracket is tight against the side of the oven. Screw B

WARNING! If the Side Bracket is removed from the oven for usage without the trim kit, hazardous situations can be avoided by reinstalling Screw B into the hole between the louvers on the side of the oven.

WARNING! Do not use a drill bit to create the screw hole. This can damage the oven cavity and create an unsafe oven.

Screw A

6 INSTALL THE MICROWAVE OVEN

Plug the power cord into the wall receptacle. Slide the microwave oven assembly gently into the cabinet, using care not to pinch the power cord. Be sure to keep the assembly centered as it slides back to where the tongue of the base support bracket goes through the rear slots. The top edges of the base pan should now be centered right to left in the opening. The base pan and top bracket front flange should be tight against the cabinet, and the V-notch should match up with the mark (made in Step 1) on the cabinet. Rear Slots

1 Ft = 0.3 m 1” = 2.5 cm

3

Document info
Document views11
Page views11
Page last viewedWed Oct 26 03:07:15 UTC 2016
Pages4
Paragraphs168
Words1641

Comments