7 CHECK LEVELING
Check the leveling by placing a level at the front and sides of the microwave. It may be necessary to add wood shims under the bottom duct to level the microwave front-to-back or side-to-side.
10 INSTALL THE TRIM KIT FRAME A Position the assembled Trim Kit frame around the oven.
Open the oven door, and locate the 4 screw holes (two on the top and two on the bottom edge of the door frame).
t h e T r i m
K i t b y d r i v i n g f o u r s c r e w s
through the oven into the Trim Kit.
CAUTION! Start all screws before tightening any one screw. Do not overtighten screws since it can cause misalignment of top/side strips.
8 INSTALL THE BOTTOM BRACKET
Install by placing the bottom bracket on the front of the base pan and flush with the bottom of the oven. Align the two screw holes, and drive two screws (D) through the bottom bracket into the base pan.
9 SECURE THE TOP AND BOTTOM BRACKETS TO THE CABINET
Ensure the top and bottom bracket front flanges are tight against the cabinet, and that the screw holes are aligned. Drive 4 screws (E) through the top and bottom brackets into the cabinet.
11 REPLACE ANY LOOSE ITEMS A Your trim kit is now fully installed. Replace the turntable and turntable support that was removed from inside the microwave oven.
Keep these installation instructions and extra screws for future reference and need. Do not place them in the microwave oven.
e p l a c e
t h e h
o u s e f u s e , o r c l o s e
e c i r c u
breaker to restore power at the service panel.
1 Ft = 0.3 m 1” = 2.5 cm
WARNING! If the Side Bracket is removed from the oven for usage without the trim kit, hazardous situations can be avoided by reinstalling Screw B into the hole between the louvers on the side of the oven.
READ CAREFULLY. KEEP THESE INSTRUCTIONS
Printed In Malysia