X hits on this document

112 views

0 shares

0 downloads

0 comments

26 / 37

The setup menu allows access to setup parameters and functions that control the system behavior.

6.0 Entering Function Mode

  • If Les Paul Standard 2010 Limited is not poweredup, pull the MCK out and push Enter four

times briefly, in quick succession. Each press must be within a halfsecond of the previous press.

    • If Les Paul Standard 2010 Limited is already in a Bank other than the Red Bank, push Enter briefly in quick succession until the Red Bank appears.

      • 6.1

        Selecting Setup Mode

1. Once Les Paul Standard 2010 Limited is in the Red Bank, rotate the MCK fully counterclockwise to the b# position. The Display Matrix shows a filledin circle. 2. Push Enter for longer than one second; the Display Matrix shows a while “enter” symbol (an arrow with a rightangle tail). 3. Push Enter again for longer than one second. The Display Matrix now shows a cyan enter symbol 4. To change a setup parameter, you first need to enter its ID number, and then the value. Enter ID numbers sequentially by turning the MCK to the first digit and pushing Enter briefly. If the ID number has two digits, rotate the MCK to the next digit and push Enter briefly. If the ID number has three digits, rotate the MCK again to the third digit, and push Enter briefly. When you press Enter after selecting a digit, the number in the Display Matrix flashes red briefly for confirmation. 5. After entering the ID number, turn the MCK fully counterclockwise to the Enter position (cyan arrow with rightangle tail) and push Enter briefly. The MCK will show the entered ID number, then a question mark to indicate that you can now enter the parameter value. 6. Enter the parameter value the same way as you entered the setup function ID: Rotate the MCK to the desired number, and push Enter briefly (repeat for multidigit values). After pushing Enter, the number in the Display Matrix will flash red for confirmation. 7. After entering the value, turn the MCK fully counterclockwise to the Enter position (cyan arrow with rightangle tail) and push Enter briefly. The Display Matrix will show the entered parameter value, then flash all outer LEDs green to confirm that the value has been accepted. 8. Exit the Setup menu by pushing Enter for more than one second.

The following set of tables shows the various usereditable Functions available in Function Mode, but please notes the following important points. Note 1: The function's “clickstream” shown in each chart abbreviates the MCK operations needed to edit the function. To save space and text:

  • It's assumed you've already completed steps 13 under Selecting Setup Mode.

  • The § symbol means, “rotate the MCK fully counterclockwise then push Enter briefly.”

Document info
Document views112
Page views112
Page last viewedSat Dec 10 17:24:08 UTC 2016
Pages37
Paragraphs875
Words14062

Comments