X hits on this document

82 views

0 shares

0 downloads

0 comments

31 / 37

Press the Display Matrix momentarily, then wait for the red “?” to appear Rotate MCK to the cyan “Y” (“Yes”), then press the Display Matrix momentarily Rotate MCK to the “Enter” sign, then press the Display Matrix momentarily To exit, push Enter for more than one second. hange your mind about resetting, in Step 3, choose “N” (“No”) instead of “Y.”

Reset stepper configuration: Resets RoboHeads' speed and acceleration Result Do the clickstream on the right, then rotate the MCK fully counterclockwise Press the Display Matrix momentarily, then wait for the red “?” to appear Rotate MCK to the cyan “Y” (“Yes”), then press the Display Matrix momentarily Rotate MCK to the “Enter” sign, then press the Display Matrix momentarily To exit, push Enter for more than one second. hange your mind about resetting, in Step 3, choose “N” (“No”) instead of “Y.”

Clickstream 106 §

Reset all: Resets all configuration data to the factory defaults Result Do the clickstream on the right, then rotate the MCK fully counterclockwise Press the Display Matrix momentarily, then wait for the red “?” to appear Rotate MCK to the cyan “Y” (“Yes”), then press the Display Matrix momentarily Rotate MCK to the “Enter” sign, then press the Display Matrix momentarily To exit, push Enter for more than one second. hange your mind about resetting, in Step 3, choose “N” (“No”) instead of “Y.”

Clickstream 109 §

Step 2 Step 3 Step 4 Step 5 Note: If you c

Function 106

Step 1 Step 2 Step 3 Step 4 Step 5 Note: If you c

Function 109

Step 1 Step 2 Step 3 Step 4 Step 5 Note: If you c

Appendix A: Les Paul Standard 2010 Limited Electronics Block Diagram

Document info
Document views82
Page views82
Page last viewedFri Oct 28 19:48:31 UTC 2016
Pages37
Paragraphs875
Words14062

Comments