X hits on this document

137 views

0 shares

0 downloads

0 comments

39 / 46

6) Tool Area / Woodcutting

Maximum points 41

5

4

3

2

1

Tool/woodcutting area is out of the way

Tool/woodcutting area labeled

Tool storage          Maximum points 10

    All tools are to be stored in the woodcutting area in a tool box and/or rack near the gate

    All tools sheathed

Woodcutting area          Maximum points 5

    Woodcutting area should be a minimum of 10’ X 10’

    The woodcutting area is roped off three foot high

    Roped off lines have warning markers on them

    There should be a gated entrance to the woodcutting area

    There is a chopping block in the center of the area

Tool Rack          Maximum points 5

    The two support poles are made of wood that is approximately the same size diameter and length or one support pole and one tree that are approximately the same size diameter

    The two bracing poles are made of wood that is approximately the same size diameter and is 1½’ to 3’ in length

    The two bracing poles are correctly lashed using square lashing

    The tool rack is between 3’ to 4’ in height

    The tool rack is sturdy and secure

Saw Buck          Maximum points 12

    The saw buck is sturdy and secure

    The sawbuck should be located in the woodcutting area

    The two sets of support poles are made of wood that is approximately the same size diameter and length

    The two sets of support poles are correctly lashed using diagonal lashing

    The two bracing poles are located just below the apex

    The two bracing poles are made of wood that is approximately the same size diameter and no longer than 36 “

    The two bracing poles are correctly lashed using square lashing

    The saw buck is between 2½’ to 3½’ in height at the apex

Wood Pile          Maximum points 3

    The wood pile is located near by to the woodcutting area

    The wood pile is grouped into tinder, kindling and fuel

    The wood pile is covered

Tool and Woodcutting Area TOTAL_____

Document info
Document views137
Page views137
Page last viewedSat Dec 10 14:40:24 UTC 2016
Pages46
Paragraphs1477
Words11803

Comments