X hits on this document

PDF document

Copyright KLANN-Spezial-Werkzeugbau-GmbH 4.E1 - page 27 / 34

144 views

0 shares

0 downloads

0 comments

27 / 34

KL-0255-11

KL-0055-50

KL-9055-1

KL-9055-2

Angle of adjustment

Lower lug on shock absorber

Tools for Changing Springs and Shock Absorbers

KL-0255-11

Additional tool set for Audi A6

(for use with adjusting fixture KL-0255) (German Utility Model)

Suitable for Audi A6 (04/04 onwards) front axle.

The additional tool set, when used with the clamping and adjusting fixture KL-0255, makes clean, quick adjustment of the spring plate possible in relation to the retaining lug of the shock absorber strut. With the adjusting gauge, the precise amount of offset between the lower shock absorber strut mounting and the upper spring plate can be adjusted correctly (see picture).

Note for VW and Audi vehicles:

The front spring/shock absorber struts on VW-Audi vehicles must be pre-adjusted on the workbench, so that the upper mounting point (the spring plate) and the lower shock absorber strut mounting (fork/shock absorber lug) are correctly aligned with one another.

Unless this work is undertaken first, the shock absorber strut cannot be installed, because the fastening points between the shock absorber strut and the body/axle beam will not be aligned.

If the shock absorber strut mounting is forced into the correct position, the O-rings for level control will be damaged and the shock absorber strut will be distorted, which could lead to drumming noise and cause the vehicle to handle incorrectly.

KL-0055-50 Holding Fixture

(German Utility Model)

For MacPherson Struts, Shock-Absorbers and Steering Racks.

The strut vise has to be screwed on the workbench and enables a clean, safe and quickly repairing. Strut axles should NOT be tensed in a vice for mounting (deformation).

KL-9055-1

Holding Fixture

Holding Fixture for the Spring Compressors KL-9002 and KL-9001. The Fixture can rotate through 360° so allowing Struts to be clamped horizontally or vertically.

KL-9055-2 Holding Fixture

Holding Fixture suitable for the Spring KL-9002 and KL-9001.

Compressors

1-27

Copyright KLANN-Spezial-Werkzeugbau-GmbH 4.E1n

1

Document info
Document views144
Page views144
Page last viewedSat Jan 21 11:01:10 UTC 2017
Pages34
Paragraphs2221
Words10996

Comments