X hits on this document

139 views

0 shares

0 downloads

0 comments

27 / 58

Chapter 2

Setting Up Dial via Office Features

Setting Up DVO Optimization for Toll Reduction

Applying DVO Optimization Settings for Toll Reduction to Devices

Use this procedure to apply DVO optimization settings for toll reduction to devices.

Before You Begin Make sure you completed all previous procedures in this chapter.

Procedure

Step 1 Step 2

Sign in to the Cisco Unified Communications Manager Administration portal. On the Mobile Identity screen for the device, select an appropriate Mobility Profile and save the change.

Step 3

On the Phone Configuration screen for the user, set the Dial via Office Policy to Let Server Choose, save the change, and reset the device.

Step 4 Step 5

In Cisco Mobile, select Options > Sign in to calling and wait while the settings are updated. Test your configuration using the following guidelines: Watch the phone carefully when you make a call; the Dial via Office number appears briefly.

Make sure the number that is dialed is the correct number for DVO optimization for toll reduction. If you did not configure the system correctly, the call may succeed but may use a DID number that incurs a higher cost than intended.

You may need to have users in different locales test Mobility Profiles that are designed for those locales, if the numbers are designed to be routable only from those locales.

Note

For information about setting up Mobility Profiles, see the “Mobility Profile Configuration” section in the “Cisco Unified Mobility” chapter of Cisco Unified Communications Manager Features and Services Guide, Release 8.5 at h t t p : / / w w w . c i s c o . c o m / e n / U S / d o c s / v o i c e _ i p _ c o m m / c u c m / a d m i n / 8 _ 5 _ 1 / c c m f e a t / f s g d - 8 5 1 - c m tml. . h

Administration Guide for Cisco Mobile for Nokia, Release 8.5

2-19

Document info
Document views139
Page views139
Page last viewedSat Dec 03 16:09:21 UTC 2016
Pages58
Paragraphs1352
Words17295

Comments