Instructing Users About How to Set Up Cisco Mobile for Nokia on the Phone Setting Up Cisco Mobile for Deployments Without Cisco Unified Communications Manager
<List of the additional required access points. If your deployment includes Cisco WebEx Connect, have users specify the generic Internet access point for the third access point.>
For assistance, do the following: S e e t h e F A Q s a t h t t p : / / w w w . c i s c o . c o m / e n / U S / p r o d u c t s / p s 7 2 7 1 / p r o d u c t s _ u s e r _ g u i d e _ l i s t . h t m l .
Contact <email address, phone numbe , and so on, of support personnel at your company>.
Setting Up Cisco Mobile for Deployments Without Cisco Unified Communications Manager
If your deployment does not include a supported version of Cisco Unified Communications Manager, users must manually set up Cisco Mobile on their phones.
Sending Setup Instructions to Users
Send users an email message with instructions for setting up Cisco Mobile. This email message includes instructions for all users. Before You Begin
Create your email message using the template in How to Set Up Cisco Mobile on Your Phone, page 7-6. Review the template and gather the information <in italics>.
Create the email message with instructions for setting up Cisco Mobile. Start with the template referenced in the Before You Begin section of this procedure.
Replace all italicized information in the template with specific information for your company. Do not include the angle brackets in the final text.
Create, remove, or modify steps as needed.
Suggestion: For the subject line of the message, use How to set up Cisco Mobile on your Nokia Phone.
Send the email message.
Administration Guide for Cisco Mobile for Nokia, Release 8.5