X hits on this document

33 views

0 shares

0 downloads

0 comments

6 / 8

These holes are, again, in a place that will be concealed should you ever decide to re-install the original grille. With the holes drilled, carefully place the upper grille in position and loosely install all 6 nylon ties. Make final adjustments to the upper grille and then fully tighten the 6 ties. Cut the tails from the ties.

Figure 3. Location of holes on tabs (upper grille opening, shown with nylon ties inserted.)

  • 3)

    INSTALL SIDE VENT GRILLES

    • 3.1)

      Loosen the underbody. Remove the 5 bolts shown in

Fig. 4 using a 10mm socket to gain access to the rear of the vent opening.

Figure 4. Remove five 10mm bolts securing the underbody. 7

Document info
Document views33
Page views33
Page last viewedTue Jan 17 19:46:51 UTC 2017
Pages8
Paragraphs58
Words1057

Comments