X hits on this document

126 views

0 shares

0 downloads

0 comments

5 / 44

ReCon Series 50 Shapes Data

Shapes

ReCon Series 50 units are available in a large variety of shapes. These shapes are designed to enhance the aesthetic appearance of a finished retaining wall. In addition, the large selection provides for ease and simplicity in the installation process without adding undue complexity for designers, installers and manufacturers alike.

The shapes shown are representative of the most common ReCon Series 50 block shapes.

Weight

Volume

Coverage

662

4.57

2.67

Batter 3.6°

Name

Half Middle Block - 24”

Unit ID HM24

Dimensions 16 in. x 24 in. x 24 in.

Weight

Volume

Coverage

1067

7.36

2.67

Batter 3.6°

Name

Half Middle Block - 45”

Unit ID HM45

Dimensions 16 in. x 24 in. x 45 in.

Weight

Volume

Coverage

710

4.90

2.67

Batter 3.6°

Name

Half Base Block - 24”

Unit ID HB24

Dimensions 16 in. x 24 in. x 24 in.

Weight

Volume

Coverage

967

6.67

2.67

Batter 3.6°

Name

Half Middle Block - 39”

Unit ID HM39

Dimensions 16 in. x 24 in. x 39 in.

Weight

Volume

Coverage

458

3.16

2.67

Batter 3.6°

Name

Half Top Block - 24”

Unit ID HT24

Dimensions 16 in. x 24 in. x 24 in.

Weight

Volume

Coverage

1457

10.04

5.33

Batter 3.6°

Name

Full Base Block - 24”

Unit ID FB24

Dimensions 16 in. x 48 in. x 24 in.

Actual block shapes and texture options vary by region. Check with your local supplier to determine availability.

Weight

Volume

Coverage

1411

9.73

5.33

Batter 3.6°

Name

Full Middle Block - 24”

Unit ID FM24

Dimensions 16 in. x 48 in. x 24 in.

Weight

Volume

Coverage

2276

15.7

5.33

Batter 3.6°

Name

Full Base Block - 39”

Unit ID FB39

Dimensions 16 in. x 48 in. x 39 in.

Because ReCon Series 50 units are manufactured from wet-cast, air-entrained concrete, they lend themselves to a varying degree of customization. Many existing shapes and face textures were originally developed to accommodate the needs of an owner, designer or installer. If some unique shape or texture is required it may be possible to develop products not already available. Given a reasonable amount of time, ReCon manufacturers should be able to determine the viability and cost estimate of such a request.

Page 5

Document info
Document views126
Page views126
Page last viewedFri Dec 09 18:49:11 UTC 2016
Pages44
Paragraphs2544
Words14497

Comments