There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider.
Features using Bluetooth technology, or allowing such features to run in the background while using other features, increase the demand on battery power and reduce the battery life.
A Bluetooth connection does not require that the compatible phone and your internet tablet be in line of sight, but both devices should be within 10 metres (32 feet) of each other. Connections can be subject to interference from obstructions, such as walls or other electronic devices.
Do not create connections to devices using Bluetooth technology that you do not trust.
Select a phone
To select a phone to be used for internet connection, tap
and select Settings > Control panel. In Control panel, select Phone. Although only one device can be selected as a phone at a time, you can pair several devices with your internet tablet.
To pair a phone with your internet tablet, do the following:
1. Activate the Bluetooth connection on your mobile phone.
In Control panel > Phone, select New. Select a phone opens, and your device begins to search for compatible devices that support Bluetooth wireless technology.
Select the desired phone from the list of found devices and OK. Your device generates a passcode.
In Pair with device, use the generated passcode or replace it with a passcode of your own. To define whether the paired device should be trusted (your phone can connect to the internet tablet without notification) or not after it is paired, select or deselect Set as trusted device. Select OK, and enter the same passcode on your compatible phone.
5. After successful pairing, the mobile operator setup wizard is presented. Use it for saving your internet connection settings. If you have already saved the settings or plan to save them later from the control
panel, select Cancel. To access the setup wizard afterwards, tap
select Settings > Control panel. In Control panel,
Tools > Mobile operator setup wizard....
6. Select Finish to save the settings.