X hits on this document

PDF document

Chrysler-Dodge Radio Wire Harnesses - page 1 / 2

5 views

0 shares

0 downloads

0 comments

1 / 2

www.installdr.com

Chrysler-Dodge Radio Wire Harnesses

Majority Of Vehicles

Typical Dodge/Chrysler

Typical New Radio

In Dash Wire Color

Equivalent Wire Color

Pin

What It Is

A

B

C

D

E

F

G

Black Plug

H

I

J

K

L

M

N

Gray Plug

AS VIEWED FROM MATING END OF CONNECTOR

Blue w/ White Stripe Brown w/ Yellow Stripe Purple Dark Green Blue w/ Orange Stripe Brown w/ Blue Stripe

Purple w/ Black Stripe Green w/ Black Stripe Gray White Purple Green

White (use for Infinity Radio) Blue

Pink or Pink w/ White Stripe Red w/ White Strip

Yellow Red

Do Not Use Do Not Use Blue w/ Red Stripe Brown w/ Red Stripe

Gray w/ Black Stripe White w/ Black Stripe

A B C D E F G H I J K L M N

Right Rear Spkr (-) Left Rear Spkr (-) Right Front Spkr (+) Left Front Spkr (+) Right Rear Spkr (+) Left Rear Spkr (+) Power Antenna/Amp +12 Volt Battery Wire +12 Volt Ignition Wire Radio Dimmer Wire Headlight Dimmer Wire Right Front Spkr (-) Left Front Spkr (-) No Wire

Metal Braid Or Plastic Connector

Attached To Back Of Radio Is The Ground Wire Black (see TIP)

If your original radio had a braided strap bolted to the rear of the radio.

TIP:

Crimp a ring terminal to the new radios ground wire and insert a bolt through both connectors to connect the ring terminal of the braided ground wire to the ring terminal attached to the new radios ground wire.

If your original radio had a plastic connector containing a single wire plugged into the rear of the radio.

TIP:

Crimp a male tab spade to the new radios ground wire. Slide it into the female tab spade connector that had originally snapped into the rear of the factory radio.

If your original radio or speaker grills were labeled or marked with ‘INFINITY’

TIP:

Crimp a male tab spade to the new radios ground wire. Slide it into the female tab spade connector that had originally snapped into the rear of the factory radio to ground the Infinity amp and activate the ‘Infinity’ sound system.

Note: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color coded the wires from the auto makers in dash wire harness to match typical aftermarket radio wire colors.

** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle. This is another reason to use a snap on wire harness adapter. **

Publication, Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohibited. Protected By U.S. Copyright Laws. © 1997,1998,1999,2000.

All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications, And Other Accessory Products Into Mobile And/Or Vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting From The Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The Vehicle Itself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or Individual.

Document info
Document views5
Page views5
Page last viewedSat Oct 29 00:21:18 UTC 2016
Pages2
Paragraphs141
Words1285

Comments