X hits on this document

88 views

0 shares

0 downloads

0 comments

19 / 30

HOW TO USE PROGRAMS DIRECTLY FROM OUR WEB SITE

To use programs from our Web site, the treadmill must be connected to your home computer. See HOW TO CONNECT THE TREADMILL TO YOUR COMPUTER on page 17. In addition, you must have an internet connection and an internet service provider. A list of specific system requirements are found on our Web site.

Follow the steps below to use a program from our Web site.

1

Insert the key into the console.

See HOW TO TURN ON THE POWER on page 10.

2

Select the iFIT.com mode.

When the key is inserted, the manual mode will be se- lected. To use a program from our Web site, press the iFIT.com button. The iFIT.com indi- cator will light.

3

Go to your computer and start an internet connection.

4

Start your web browser, if necessary, and go to our Web site at www.iFIT.com.

5

Follow the desired links on our Web site to se- lect a program.

Read and follow the on-line instructions for using a program.

6

Follow the on-line instructions to start the program.

When you start the program, an on-screen count- down will begin.

19

7

8

9

Return to the treadmill and stand on the foot pads. Find the clip attached to the key and slide the clip onto the waistband of your clothes.

When the on-screen countdown ends, the program will begin and the walking belt will begin to move. Hold the handrails, step onto the walking belt, and begin walking. During the program, an electronic “chirping” sound will alert you when the speed and/or incline of the treadmill is about to change. CAUTION: Always listen for the “chirp” and be prepared for speed and/or incline changes.

If the speed or incline settings are too high or too low, you can manually override the settings at any time by pressing the Speed or Incline buttons on the console. However, when the next “chirp” is heard, the speed and/or incline will change to the next settings of the program.

To stop the walking belt at any time, press the Stop button on the console. The Time/Pace dis- play will begin to flash. To restart the program,

press the Start button or the Speed

button. After

a moment, the walking belt will begin to move at 1 mph. When the next “chirp” is heard, the speed

and incline will change to the next settings of the program.

When the program is completed, the walking belt will stop and the Time/Pace display will begin to flash. Note: To use another program, press the Stop button and go to step 5.

Note: If the speed or incline of the treadmill does not change when a “chirp” is heard, make sure that the iFIT.com indicator is lit and that the Time/Pace display is not flashing. In addi- tion, make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord.

Follow your progress with the track and the displays.

See step 5 on page 10.

When the program has ended, remove the key.

See step 7 on page 13.

Document info
Document views88
Page views88
Page last viewedSat Dec 10 20:52:15 UTC 2016
Pages30
Paragraphs1324
Words13021

Comments