VII) Camera Usage
Use Caution, the edge of the base clip may be sharp. When unscrewing the cover make sure the clip is in the same direction as the lens. Observe the following precautions when unscrewing the cover of the camera:
Unscrew the cover at the end of the unit.
Place your finger on the 'lip', which is on the bottom half of the rear of the unit, and pull in an upward direction to open the battery slot door.
Insert 2 x AA alkaline batteries into the battery slot with the polarity in the direction as shown.
Close the battery slot door and screw on the end of unit cover.
Note: When the battery is low, the low battery icon will appear on the LCD screen.
Always upload video footage to your PC prior to replacing batteries to avoid memory loss
Do not mix old and new batteries together. Replace both batteries at the same time.
Remove the batteries if the camera is not going to be used for extended periods of time.
c) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used together.
Turning the Camera On Press and hold the On/Off Button
for 2 seconds (two
beeping sounds). The LCD screen will show the remaining time. For your safety, do not press any buttons on the camera
during sports activities.
Turning the Camera Off 1. Press and hold the On/Off Button
for 2 seconds
(two beeping sounds). The LCD screen will turn off. 2. The camera will be turned off automatically after 30 minutes of not being used unless it is in USB mode.
Note: If the camera is connected to your PC, you have to unplug the USB cable to turn the camera off.
Note: Ensure that the ATC3K is turned off during the insertion or the removal of the SD card. The card and the data may be damaged if the SD card is inserted or removed while the camera is on.