X hits on this document

184 views

0 shares

0 downloads

0 comments

29 / 57

Randolph County                                                                                                                     Bid 07-1001

Due Date:  Thursday, October 25, 2007, 3:00P.M.                                                         EMS Ambulances

_____________________________________________________________________________________

7.6Bumpers and Steps:  

The chassis manufacturer's standard bumper shall be furnished on the front of the cab.  The rear bumper and step assembly shall be a single unit constructed of 10 gauge steel "C" formed channel and .100 inch thick aluminum diamond plate.  The center step of the bumper assembly shall be designed to allow it to "Flip" up out of the way for easier loading of the patient.  This step shall be open grate material or “punched” to meet the requirements of KKK-A-1822E.

A stainless steel hinge with a center pin diameter of at least .250 inch shall be used to attach the "flip" up section of the rear step to the main rear bumper assembly. This bumper assembly shall be bolted to supports that have been welded to the chassis frame. There shall be eye-beam constructive skid plates mounted as part of the frame of the bumper.  This assembly shall be bolted to the frame of the chassis with a minimum of 5/8" Grade 8 bolts.  There shall be at least one-half inch clearance between the bumper assembly and the rear of the modular body to allow water drainage.

Above the bumper assembly and below the rear doors, there shall be full length riser of aluminum diamond plate for a protective kick panel.  The kick panel shall be securely fastened with solid mandrel; aluminum drive rivets and run the full rear width of the module.  Screws or "pop" rivets are not acceptable.

Does your bid comply with this requirement?Yes   _____   No   _____

7.7Fenders:

Stainless steel fenderettes shall be provided around the rear wheel wells to provide protection against wheel wash.   A gasket shall be placed between the fender and the body of the vehicle.

Does your bid comply with this requirement?Yes   _____   No   _____

7.8Undercoating:

Underside of chassis and modular box shall be undercoated per DODGE (preferred) chassis guidelines.  

Does your bid comply with this requirement?Yes   _____   No   _____

Page 29 of 56

Document info
Document views184
Page views184
Page last viewedSat Dec 10 23:04:53 UTC 2016
Pages57
Paragraphs1140
Words17169

Comments