X hits on this document





32 / 57

Randolph County                                                                                                                     Bid 07-1001

Due Date:  Thursday, October 25, 2007, 3:00P.M.                                                         EMS Ambulances


8.4.6Vertical corners of the modular body shall be constructed of 6063-T6 extruded aluminum double hollow corner posts that are specifically designed to provide added material thickness at all points of stress and provide for secure interlocking of attached structures for added strength. This extruded post is designed with a unique 45 degree angled appearance while maintaining very high strength and impact energy absorption.  Integrated DOT marker lights shall be included in the corners, with warning light LED upgrade, front corners amber, and rear corners red.

Does your bid comply with this requirement?Yes   _____   No   _____

8.4.7Side assemblies shall be reinforced utilizing aluminum 2" x 2" architectural box tubing.  The aluminum shall be 6061-T6.  The side structures shall frame a perimeter around door opening. Intermediate skin stiffeners shall be located to preclude skin deformation.

Does your bid comply with this requirement?Yes   _____   No   _____

8.4.8Additional structural integrity shall be obtained through the use of gusset plates at all contact points between the corner assembly and the roof perimeter.  Gusset plates shall be .250 inch aluminum and shall be welded at all contact points.

Does your bid comply with this requirement?Yes   _____   No   _____

8.4.9The ambulance body as a unit shall be designed and constructed to provide impact resistance.  The manufacturer must provide documentation that the body being bid meets the Static Load Test Code for Ambulance Body Structure, AMD Standard 001.

Does your bid comply with this requirement?Yes   _____   No   _____

8.4.10This Agency is extremely concerned with purchasing the vehicle from a manufacturer who can provide the necessary service after the sale with a minimum of confusion. With this in mind, this vehicle shall be constructed with the exception of the chassis, by the prime (second stage manufacturer) contractor. This shall be especially true of the modular body. This clause will apply to any type of subcontract, lease, rental or any other similar arrangement.  The Bidder may be required by this Agency to prove compliance with this requirement. No exceptions shall be taken to this requirement since this Agency will not accept the above mentioned modular body warranty from a manufacturer who is not the builder of the body.

Does your bid comply with this requirement?Yes   _____   No   _____

Page 32 of 56

Document info
Document views242
Page views242
Page last viewedTue Jan 24 09:35:58 UTC 2017