X hits on this document

159 views

0 shares

0 downloads

0 comments

35 / 57

Randolph County                                                                                                                     Bid 07-1001

Due Date:  Thursday, October 25, 2007, 3:00P.M.                                                         EMS Ambulances

_____________________________________________________________________________________

The three (3) patient compartment doors shall be fitted with stainless steel, flush fit, large "automotive style" hardware that will easily accommodate the gloved hand when opening.  The patient compartment doors shall be provided with a keyed lock and the rear doors shall be lockable from the inside without a key per FMVSS.  Both rear doors shall have exterior handles accessible from the rear.

Does your bid comply with this requirement?Yes   _____   No   _____

8.7.5Locking hardware shall be flush fit on the inside of the patient compartment doors as well as the outside.  The interior door pans of the exterior compartments shall be bright aluminum diamond plate.  Each of the three (3) patient compartment doors shall be equipped with an anodized aluminum frame upper window with a total viewing area of at least 250 square inches per door.

Does your bid comply with this requirement?Yes   _____   No   _____

8.8Door Latches, Hinges and Hardware:  

When the doors are opened, the hinges, latches and door checks shall not protrude into the access area.  All patient compartment doors shall employ the same type locking hardware.  All door latches shall comply with requirements of FMVSS 206.  

Does your bid comply with this requirement?Yes   _____   No   _____

8.8.1Locking devices shall be two-stage rotary latches and shall be FMVSS.  Where applicable, there shall be two door latches, one at the top and one at the bottom, controlled by a single locking handle.  The latches shall lock into an adjustable "Nader" type pin located in the door frame.  The Nader will utilize a captive nut to provide adjustment and replacement without loss of the nut plate.  The locking system shall be actuated from the locking handle by metal push rods.

Does your bid comply with this requirement?Yes   _____   No   _____

8.8.2All door handles shall be flush, large "automotive style" hardware that will easily accommodate the gloved hand when opening.  On the curb side and rear doors, the inside handles shall be equipped with an inside door lock.  All exterior storage compartments and module entry doors shall be lockable with the same key.

Does your bid comply with this requirement?Yes   _____   No   _____

8.8.2.1All entry doors shall have horizontal aluminum reinforcements both welded and bolted through the extruded door frame.  All entry doors will have closed cell block foam insulation.   

Does your bid comply with this requirement?Yes   _____   No   _____

Page 35 of 56

Document info
Document views159
Page views159
Page last viewedThu Dec 08 02:49:43 UTC 2016
Pages57
Paragraphs1140
Words17169

Comments