X hits on this document

170 views

0 shares

0 downloads

0 comments

48 / 57

Randolph County                                                                                                                     Bid 07-1001

Due Date:  Thursday, October 25, 2007, 3:00P.M.                                                         EMS Ambulances

_____________________________________________________________________________________

11.5Emblems and Markings:   

The material for the emblems and markings shall be applied using reflectorized material conforming to Federal Specification L-S-300, Type I, Class 1 or 3 reflectivity 1. The reflective color used shall be blue (color a) and white (color i) when applicable (KKK decal package). The emblems and markings shall be of the type, size, color, and location as follows:

Front: The word “AMBULANCE”, mirror imaged, shall be in block, blue, die cut style letters, not less than 10 cm (4 in.) high, centered above the grille, on the front roll of chassis hood with the placement of the word “AMBULANCE” on the curved surface of the hood.   A “Star of Life” in 7.6 cm (3 in.), blue, die cut style, with a white border, conforming to Figure 4 (size A) shall be located both to the right and left of the word “AMBULANCE.”

Side and Rear:  The word “AMBULANCE” shall be in block, blue, die cut style letters of not less than 15 cm (6 in.) in height, centered, with a white border, alongside or under the “Star of Life” on each side and rear of the vehicle body.  A “Star of Life”, not less than 40.6 cm (16 in.), in blue, die cut style, with a white border, conforming to Figure 4 (size C), on the right and left side panels. A “Star of Life” emblem, size B, shall be provided on each rear door.

Top:  A “Star of Life”, of not less than 81 cm (32 in.) (size D) in blue, die cut style,  conforming to Figure 4 (may be without the white Staff of Aesculapius), shall be provided on the ambulance rooftop.

NOTE:  All emblems and markings with the exception of the roof “Star of Life” shall be furnished loose for future installation.

Does your bid comply with this requirement?Yes   _____   No   _____

11.6     Markings, Data Plates, Warranty Notice:

Markings, data plates and warranty notice shall meet the requirements of paragraph 3.19 of Federal Specification KKK-A- 1822D or latest revision.

Does your bid comply with this requirement?Yes   _____   No   _____

Page 48 of 56

Document info
Document views170
Page views170
Page last viewedFri Dec 09 20:10:09 UTC 2016
Pages57
Paragraphs1140
Words17169

Comments