X hits on this document

PDF document

1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING - page 3 / 8

34 views

0 shares

0 downloads

0 comments

3 / 8

Version

4.0 / US

Revision date

04/09/2011

Print Date

04/06/2013

Page

3/8

MATERIAL SAFETY DATA SHEET 844-0982 CHROMA-CHEM®LEAD FREE ORANGE

UO

Material no. Specification Order Number

139811

42.22 °C ,

108 °F

Method:

Setaflash Closed Cup

Combustible Liquid

OSHA Flammability Classification

5. FIRE-FIGHTING MEASURES

Flash point

Suitable extinguishing media Use water spray or fog, foam, dry chemical or CO2.

Specific hazards during fire fighting

Combustible liquid. Vapors can travel to a source of ignition and flash back. Explosive mixtures may occur at temperatures at or above the flashpoint.

Further information

As in any fire, wear self-contained positive-pressure breathing apparatus, (MSHA/NIOSH approved or equivalent) and full protective gear. Containers can build up pressure if exposed to heat (fire). Cool with water spray.

6. ACCIDENTAL RELEASE MEASURES

Additional advice

Absorb spill with inert material, then place in a chemical waste container. After removal, flush contaminated area with water and collect for disposal. Clean up spills immediately. Remove sources of ignition and ventilate area. Use a respirator and other protective equipment as outlined in Section 8. Obey relevant local, state, provincial and federal laws and regulations. Do not contaminate any lakes, streams, ponds, groundwater or soil.

7. HANDLING AND STORAGE Handling

Safe handling advice

Keep away from heat. Keep away from sparks, flames and other sources of ignition. Avoid contact with eyes, skin and clothing. Avoid breathing vapor or mist. Use with adequate ventilation. The need for grounding and bonding of containers in accordance with OSHA 29 CFR 1910.106 and NFPA 77 should be assessed for all product transfers. Follow all MSDS/label precautions even after the container is emptied because it may retain product residues. Wash thoroughly after handling.

Storage

Requirements for storage areas and containers

Keep in a dry, cool place. Keep container closed when not in use. Residual vapors might explode on ignition; do not apply heat, cut, drill, grind or weld on or near this container.

8. EXPOSURE CONTROLS / PERSONAL PROTECTION

Component occupational exposure guidelines

MSDS-US (R11/011) / 4/9/2011 12:47

Document info
Document views34
Page views34
Page last viewedMon Dec 05 07:44:01 UTC 2016
Pages8
Paragraphs355
Words2124

Comments