X hits on this document

PDF document

Master of Science Thesis in Electric Power Engineering - page 73 / 114

311 views

0 shares

3 downloads

0 comments

73 / 114

VOLTAGE ORIENTED CONTROL – IMPLEMENTATION

Then, using Control Desk software, you can build an interface with control panel : knobs, control buttons. You can also add visualizations : led, gauge, graph and so on.

To be able to run our system, some modification need to be done on our Simulink model.

4.3 Simulink model modification

The top level Simulink model for implementation is show in Figure 4.2.

Figure 4.2 : Top level Simulink model for dSpace implementation

ADC

Figure 4.3 : ADC example (see APPENDIX G. Figure 0.42)

The important information using ADC and DAC is shown in the following table. You need to multiply by 10 a value from ADC, and divide by 10 before sending to DAC.

Input voltage

Correspondance

Simulink

Output voltage

range

in Simulink

value

range

10V…+10V

1…+1

1…+1

10V…+10V

ADC

DAC

Table 4.2 : ADC/DAC value range

64

Document info
Document views311
Page views319
Page last viewedSun Dec 04 12:11:36 UTC 2016
Pages114
Paragraphs2263
Words17018

Comments