X hits on this document

242 views

0 shares

0 downloads

0 comments

75 / 82

FM CONTROL ID CODE PROGRAMMING (CONT.)

  • 3.

    Power Transmitter into Configuration Mode

    • A.

      Press & hold [BOOM] switch in the UP position

    • B.

      Press & release [POWER] switch in the OFF position

    • C.

      Release [BOOM] switch

The ACTIVE LED will flash once per second.

A.

YELLOW

B.

YELLOW

C.

YELLOW

4. Put Receiver into Setup

ESTOP

FAULT

-

-

ESTOP

FAULT

-

-

  • A.

    Press & hold [Setup] button until (Status) light goes from slow flash to fast flash

  • B.

    Release [Setup] button. (Status) light goes to solid GREEN, (Link) light turns off

A.

Setup Button

LINK STATUS

  • -

    GRN

LINK STATUS

Setup

-

GRN

Button

B.

NOTE: If left idle in Setup Mode for over 30 seconds, the receiver will time out. The (Link) light and (Status) light will flash RED rap- idly. To return to Setup Mode, repeat step 4.

  • 5.

    Download ID Code

    • A.

      Press & release [BOOM]

switch in the UP position

B. The R160 (Link) light goes to GREEN. Once complete, (Link) light goes to RED as the trans- mitter turns off

A.

YELLOW

B.

ESTOP

FAULT

-

-

LINK STATUS

GRN

-

NOTE: When replac- ing the receiver cover, ensure the cover snaps completely into place to create a weather proof seal around the base of the receiver.

Light Legend

Solid

Slow

Fast

Red

Green

Yellow

Flash

Flash

Light

Light

Light

10-10.0

02/15/06

Document info
Document views242
Page views242
Page last viewedFri Dec 09 19:37:08 UTC 2016
Pages82
Paragraphs3105
Words15023

Comments