Install vinyl siding, min. 42-mil thickness or equivalent, over existing siding. Cover house proper, front porch, and rear extension. Cover from top of foundation to roof overhang on all exterior walls. Install underlayment insulation. Use J channel around all outside openings. Install siding as per manufacturers‟
recommendations. Color to be chosen by owner.
SOFFIT & FASCIA
Cover all soffit, using solid or vented paneling. Cover all fascia, rake, and trim with .019 coil stock
aluminum, or use pre-formed fascia panels. Vent soffit as necessary.
Cap all windows, door casings, brick molds, sills, and drip caps with .019 coil stock. Caulk all joints.
Remove aluminum combinations (etc.), and cap all inside sills; re-install combinations.
Install vents on all gables of the house.
Install a standard aluminum door hood with a solid top, and ventilated sides. Door hood shall have crowned panels and flanges, seams with three thicknesses, beveled edges, and finished with permanent enamel. Color to be chosen by the owner. Hood should have a 28" drop, 48" width, and 36" projection,
unless otherwise specified on the bid sheets. Obtain any necessary zoning permits.
Remove existing window(s).
Close opening with appropriate size studs, 16" on center.
sheathing, insulation and exterior building paper or house wrap and finish interior and exterior to match
Window wells shall be made of galvanized steel or rust proof metal and be a minimum 20 gauge. Wells to be of sufficient height and securely anchored to the foundation and caulked to prevent water entry and to insure proper protection against earth wash. Base shall be a minimum of 4 inches of crushed rock or
gravel to help promote drainage.
\\citycr.local\sharedocs\PublicWorks\HSG\Housing Rehab\Specs-Codes\General Specifications.doc