X hits on this document

70 views

0 shares

0 downloads

0 comments

13 / 27

400

DOORS

401

DOOR REMOVAL

Remove existing door(s).

Close opening with appropriate size studs, 16" on center.

Install plywood

sheathing, insulation and exterior building paper or house wrap and finish interior and exterior to match

existing.

402

EXTERIOR WOOD DOOR

Install a new solid wood-core door. The door will have a tempered, insulated glass area. The door shall be 1¾" thick and shall be the standard 6' 8" unless otherwise specified. All surfaces shall have a waterproof exterior grade finish. The door will have three hinges. Install a key-operated, passage lock (Schlage, Weiser or equal quality) with two (2) key sets furnished to the owner. Option: Install a dead bolt lock keyed the same as the passage lockset if door is pre-bored for this type of lock. Finish with two

coats of paint or stain and two coats of varnish. frame. Weatherstrip all four sides.

Seal all six sides. Install the door to hang plumb in

403

PRE-HUNG STEEL DOOR UNIT

Install an Energy Star® labeled, pre-hung metal entrance door unit. The unit is to include new frame, brick molding, threshold, and interior casings. The door shall be 1¾" thick, filled with high density, polyurethane foam of R-14 value, and shall be a standard 6' 8" unless otherwise specified. The door skin will be 24-gauge steel and be factory primed. The door will have three hinges. Install key-operated passage locks; furnish the owner with two (2) key sets. Option: Install a dead bolt lock keyed the same as the passage lockset if door is pre-bored for this type of lock. The door will have a tempered, insulated glass area. Head and latch jambs will have a magnetic weather-strip, and the hinge jamb will have a

compression-type weather-strip. Finish with two coats of paint. Seal all six sides.

404

PRE-HUNG WOOD DOOR UNIT

Install a new solid wood-core, wood door entrance unit. The unit is to include new frame, brick molding, threshold, and interior casings. The door shall be 1¾" thick and shall be a standard 6' 8" unless otherwise specified. All surfaces shall have a waterproof exterior grade finish. The door will have three hinges. Install a key-operated, passage lock with two (2) key sets furnished to the owner. Option: Install a dead bolt lock keyed the same as the passage lockset if door is pre-bored for this type of lock. The door will have a tempered, insulated glass area. Finish with two coats of paint or stain and two coats of varnish.

Seal all six sides.

405

ALUMINUM COMBINATION STORM DOOR

Install solid core, aluminum combination storm doors. Minimum 1" thick stock aluminum storm door. Door is to be pre-hung aluminum with 3 or more hinges, storm chain, and hydraulic closer. When installing new door, install to swing the same way as the existing door. All glass must be safety glass.

Factory painted white unless otherwise specified. Install the door to hang plumb in frame.

406

WEATHER-STRIPPING

Weather-stripping for wood doors will be extruded aluminum with neoprene insert surface mounted on frame or stop. Spring bronze in door is acceptable. Threshold for wood doors with brush rubber or

neoprene insert. Door manufacturer shall furnish weather-stripping for metal door.

407

STEEL GARAGE DOOR

Install a steel, non-insulated, overhead garage door.

Doors shall be 24-gauge steel. All hardware and

bottom weather-strip will be included. Door will fit snugly against side and top stop moldings.

\\citycr.local\sharedocs\PublicWorks\HSG\Housing Rehab\Specs-Codes\General Specifications.doc

13

Document info
Document views70
Page views70
Page last viewedMon Jan 16 18:09:16 UTC 2017
Pages27
Paragraphs935
Words10325

Comments